Home › Forums › Oral & Maxillofacial surgery › BLOOD PRESSURE MEASUREMENT IN OUR CLINCS
Welcome Dear Guest
To create a new topic please register on the forums. For help contact : discussdentistry@hotmail.com
- This topic has 1 reply, 2 voices, and was last updated 11/04/2011 at 5:45 pm by Drsumitra.
-
AuthorPosts
-
11/04/2011 at 5:43 pm #11886AnonymousOnlineTopics: 0Replies: 1150Has thanked: 0 timesBeen thanked: 1 time
Before one carries out any sort of treatment it is most important to take history and this is a well known fact.
This article is just to brush up on taking bp of a hypertensive patient or one whom we suspect of having such a disorder[read:obese patients]It is not possible to derive a numerical value for blood pressure without some equipment, but a crude assessment of the circulation can still be obtained. If you can feel a radial pulse the systolic blood pressure is usually at least 80 mmHg. The character of the pulse, i.e. bounding or thready, gives a further clue. In most cases, shocked patients have cold hands and feet. (The most important exception to this is a patient who is shocked because of severe sepsis). Capillary refill time is another simple test of circulatory adequacy: press firmly on the patient’s nail bed with your thumb; release your thumb and see how long it takes for blood to return. A refill time of greater than 2 seconds suggests an inadequate circulation.
MANUAL NON-INVASIVE TECHNIQUE
This requires, at the very least, an inflatable cuff with a pressure gauge (sphygmomanometer). Wind the cuff round the arm (which should be at about heart level) and inflate it to a pressure higher than the expected blood pressure. Then deflate the cuff slowly. With a stethoscope, listen over the brachial artery. When the cuff reaches systolic pressure, a clear tapping sound is heard in time with the heart beat. As the cuff deflates further, the sounds become quieter, but become louder again before disappearing altogether. The point at which the sounds disappear is the diastolic pressure. If you have no stethoscope, the systolic blood pressure can be found by palpating the brachial artery and noting the pressure in the cuff at which it returns.initial ‘tapping’ sound (cuff pressure = systolic pressure)
sounds increase in intensity
sounds at maximum intensity
sounds become muffled
sounds disappear
Most inaccuracies result from the use of the wrong size of cuff. A narrow cuff wrapped round a fat arm will give an abnormally high reading, and vice versa. The World Health Organisation recommends a 14cm cuff for use in adults. Smaller cuffs for infants and children are available. In occasional patients, the reading obtained from one arm can be different from that obtained from the other arm. An appropriate size of cuff can be applied to the calf, and pressure estimated by palpation of the posterior tibial pulse11/04/2011 at 5:45 pm #17080DrsumitraOfflineRegistered On: 06/10/2011Topics: 238Replies: 542Has thanked: 0 timesBeen thanked: 0 timesAutomatic devices which essentially apply the same principle as the oscillotonometer have been produced (e.g. the ‘Dinamap’ made by Critikon). They require a supply of electricity. A single cuff is applied to the patients arm, and the machine inflates it to a level assumed to be greater than systolic pressure. The cuff is deflated gradually. A sensor then measures the tiny oscillations in the pressure of the cuff caused by the pulse. Systolic is taken to be when the pulsations start, mean pressure is when they are maximal, and diastolic is when they disappear. They can produce fairly accurate readings and free the hands of the anaesthetist for other tasks. There are important sources of inaccuracy, however. Such devices tend to over-read at low blood pressure, and under-read very high blood pressure. The cuff should be an appropriate size. The patient should be still during measurement. The technique relies heavily on a constant pulse volume, so in a patient with an irregular heart beat (especially atrial fibrillation) readings can be inaccurate. Sometimes an automatic blood pressure measuring device inflates and deflates repeatedly "hunting" without displaying the blood pressure successfully. If the pulse is palpated as the cuff is being inflated and deflated the blood pressure may be estimated by palpation and reading the cuff pressure on the display.
INVASIVE TECHNIQUE
This technique involves direct measurement of arterial pressure by placing a cannula in an artery (usually radial, femoral, dorsalis pedis or brachial). The cannula must be connected to a sterile, fluid-filled system, which is connected to an electronic monitor. The advantage of this system is that pressure is constantly monitored beat-by-beat, and a waveform (a graph of pressure against time) can be displayed. Patients with invasive arterial monitoring require very close supervision, as there is a danger of severe bleeding if the line becomes disconnected. It is generally reserved for critically ill patients where rapid variations in blood pressure are anticipated. -
AuthorPosts
- You must be logged in to reply to this topic.