Custom post

Welcome Dear Guest

To create a new topic please register on the forums. For help contact : discussdentistry@hotmail.com

This topic has 2 replies, 3 voices, and was last updated 22/02/2011 at 1:37 pm by tirath.

Currently, there are 0 users and 1 guest visiting this topic.

Viewing 3 posts - 1 through 3 (of 3 total)

Author

Posts
16/02/2011 at 5:32 pm #11744

Anonymous
Online
Topics: 0
Replies: 1150
Has thanked: 0 times
Been thanked: 1 time

Problems associated with fabrication of custom-cast posts with a plastic rod and autopolymerizing resin include voids in the pattern, locking of the pattern into undercuts, and resin fracture during removal of the pattern. This article describes a system for fabricating custom-cast posts with a thermoplastic resin to address these problems. The system consists of a plastic support rod and a thermoplastic resin. A custom post pattern can be quickly and easily produced by trimming the plastic rod, heating the resin either over a direct flame or in a low-temperature glue gun and seating it into a lubricated prepared canal. The resin flows well and thereby reduces voids. The resin is elastic enough to be removed from small undercuts without locking into the canal or fracturing.



20/02/2011 at 2:13 pm #16865

vedrahool123
Offline
Registered On: 21/01/2011
Topics: 1
Replies: 22
Has thanked: 0 times
Been thanked: 0 times

Another approach for achieving the advantages of custom made post and core is to Reline the fibre post with resin and luting it with a dual cure cement..



22/02/2011 at 1:37 pm #16866

tirath
Offline
Registered On: 31/10/2009
Topics: 353
Replies: 226
Has thanked: 0 times
Been thanked: 0 times

what are the failures?
Author

Posts

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.